Accuton C168-6-890
The C168-6-890 is a 7 inch bass-midrange driver with ceramic dome, being the first in an entirely new approach to accuton speaker design.
Email Us
info@diy-audio.eu
Speaker drivers
Subcategories
There are 17 products.
Active filters
Accuton C173-11-191
16 cm bass-midrange driver with ceramic cone. It has a rear vented voice coil.
Satori MW19P-8 7.5"...
The SB Acoustics Satori MW19P-8 Midwoofer is a State of The Art Neodymium magnet 7.5" 8 ohm midwoofer, featuring a proprietary Papyrus Paper cone, a high efficiency soft low damping optimum response rubber surround, BiMax spider, and a glass fiber former
Satori MW19TX-4 7.5″...
TeXtreme - Combining ultralightweight, high stiffness and controlled break-up behaviour.
Satori WO24P-4 9.5"...
The Satori range was founded to separate more expensive projects from a wider range of more affordable – but still high-end – SB Acoustics products. As we get more experience, new materials, better simulation tools, we believe in benefiting the customer w
Satori WO24P-8 9.5"...
The Satori range was founded to separate more expensive projects from a wider range of more affordable – but still high-end – SB Acoustics products. As we get more experience, new materials, better simulation tools, we believe in benefiting the customer w
SB29NRX-00 10" Passive...
This driver is built similarly to the active woofer and is a good match to the SB29SWNRX-S75 10" subwoofer. In 0.75 to 1.0 cubic foot with that woofer one has an F3 of about 35Hz. It also mates well with the SB29NRX75-6 10" woofer.
SB34NRX-00 12" Passive...
The SB Acoustics SB34NRX-00 passive radiator is a good match to the SB Acoustics woofer SB34SWNRX-S75. In 2.0 to 2.5 cubic foot box this combo will get down to 30Hz. Adding a plate amplifier with a low frequency boost would push the F3 even lower.
SB34NRX75-16 12" Woofer 16 ohm
This new 16 ohm 12″ woofer from SB Acoustic features a low distortion motor system, paper cone with rubber surround, cast Aluminum frame and 75mm voice coil. The woofer would make a fine low frequency driver for a premium 3-way system, or put two in paral
SB34NRX75-6 12" Woofer
The SB Acoustics SB34NRX75-6 12" woofer uses a large 3" voice coil on a cast aluminum chassis. Hard Paper proprietary cone materials made in-house for consistency. Low damping SBR rubber surround with high exertion and resilience.
SB34NRXL75-8 12" Woofer
The SB34NRXL75-8 12" woofer features a proprietary composition paper cone with a special coating. The rubber surround has been carefully chosen to properly dampen the cone movement. The open structure cast frame has been specially engineered for minimum r
SW26DAC-00 10" Passive...
SB Acoustics has made its new 10" passive radiator, the SW26DAC-00 to match their already active SW26DAC76 woofers. Simulating them in BassBox Pro produces some very good looking results.
SW26DAC76-4 10" Subwoofer 4...
The SB Acoustics SW26DAC76-4 10 inch 4 ohm aluminum shallow subwoofer. Can be used with very shallow enclosure’s.
SW26DAC76-8 10" Subwoofer 8...
The SB Acoustics SW26DAC76-8 10 inch 8 ohm aluminum shallow subwoofer. Can be used with very shallow enclosure’s
SW26DBAC-00 10'' Passive...
The SB Acoustics 10" passive radiator SW26DBAC-00 produces some very good results thanks to its main components: dual rigid aluminum cone structure and cast aluminum chassis that allows optimum strength.
SW26DBAC76-4 10" Aluminium...
The SB Acoustics SW26DBAC76-4 10 inch 4 ohm aluminum shallow subwoofer. Can be used with very shallow enclosure’s
SW26DBAC76-8 10" Aluminum...
The SB Acoustics SW26DBAC76-8 10 inch 8 ohm aluminum shallow subwoofer. Can be used with very shallow enclosure’s
