Best Sellers
Jantzen Audio Silver Z-Cap
1ET400A 1x425W Eigentakt...
500A 500W Pro Amplifier Module
SB15CAC30-4 5" Ceramic Woofer
SB Ceramic cones consist of an aluminum/ceramic dual layer cone. Ceramic provides a very hard and robust surface with improved sonic properties and cosmetic appearance.
Highlights
- Vented cast aluminum chassis for optimum strength and low compression
- Geometrically reinforced ceramic cone for optimum piston operation and reduced break-up
- Soft low damping rubber surround for improved transient response
- Non-conducting fiber glass voice coil former for minimum damping
- Extended copper sleeve on pole piece for low inductance and low distortion
- CCAW voice coil for reduced moving mass
- Long life silver lead wires
- Vented pole piece for reduced compression
Product details
SB Acoustics SB15CAC30-4 5" Ceramic Woofer
SB Ceramic cones consist of an aluminum/ceramic dual layer cone. Ceramic provides a very hard and robust surface with improved sonic properties and cosmetic appearance.
Other than that, ceramic cones offer smoothness and harmonic richness unavailable from conventional paper cone material. Ceramic materials also offer significantly higher stiffness numbers and slightly better internal losses than typical metals such as titanium or aluminum. Compared to polymers, paper, and other soft materials, ceramics provide: significantly higher stiffness to weight ratio, more consistent performance over a wide range of temperature and humidity as well as superior immunity to UV light and sunlight, to water and salt water and to combustibility.
Data sheet
- Impedance
- 4 Ohm
- Driver type
- Midwoofer
- Sensitivity
- 88 dB 2.83V/1m
- Resonance frequency (fs)
- 32.5 Hz
- DC resistance (Re)
- 3.1 ohms
- Mechanical Q (Qms)
- 4.61
- Electrical Q at Fs (Qes)
- 0.34
- Total Q factor (Qts)
- 0.31
- Speaker diameter
- 5"
- Voice coil inductance (L)
- 0.12 mH
- Effective mechanical mass incl air load (mms)
- 11.3 g
- Effective piston radiating area (Sd)
- 82 cm2
- Force factor (BL)
- 4.6 Tm
- Equivalent volume of compliance (Vas)
- 0.71 ft.³