Best Sellers
Jantzen Audio Superior Z-Cap
Jantzen Audio Silver Z-Cap
1ET400A 1x425W Eigentakt...
Subcategories
There are 119 products.
SB21RDC-C000-4 3/4" Ring...
Non-resonant diaphragm design for minimum high frequency break-up and dual balanced compression chamber for improved dynamics. Copper cap for reduced voice coil inductance and minimum phase shift.
SB21SDC-C000-4 Ring Dome...
The SB21SDC-C000-4’s large surround dome allows the increase of its acoustic output. Dual balanced compression chamber for improved dynamics. Saturation controlled motor system for low distortion and low resonance frequency.
SB21SDCN-C000-4 3/4" Fabric...
21mm Large surround textile dome, neodymium motor, injection faceplate.
SB23MFCL45-4...
A compact high quality subwoofer. That is optimized for smaller compact enclosures.
SB23NACS45-4 8" Aluminum...
The SB Acoustics SB23NACS45-4 features a soft low damping rubber surround for improved transient response and a geometrically reinforced aluminum cone for improved break-up control. Shorting ring in motor system for reduced distortion and vented pole piec
SB23NACS45-8 8" Aluminum...
The SB Acoustics SB23NACS45-8 features a soft low damping rubber surround for improved transient response and a geometrically reinforced aluminum cone for improved break-up control. Shorting ring in motor system for reduced distortion and vented pole piec
SB23NBACS45-4 8" Black...
The SB Acoustics SB23NBACS45-4 features a soft low damping rubber surround for improved transient response and a geometrically reinforced aluminum cone for improved break-up control. Shorting ring in motor system for reduced distortion and vented pole pie
SB23NBACS45-8 8" Black...
The SB Acoustics SB23NBACS45-8 features a soft low damping rubber surround for improved transient response and a geometrically reinforced aluminum cone for improved break-up control. Shorting ring in motor system for reduced distortion and vented pole pie
SB29NRX-00 10" Passive...
This driver is built similarly to the active woofer and is a good match to the SB29SWNRX-S75 10" subwoofer. In 0.75 to 1.0 cubic foot with that woofer one has an F3 of about 35Hz. It also mates well with the SB29NRX75-6 10" woofer.
SB29NRX75-6 10" Woofer
The SB29NRX75-6 10" woofer features a proprietary composition paper cone with a special coating. The rubber surround has been carefully chosen to properly dampen the cone movement. The open structure cast frame has been specially engineered for minimum re
SB29RDAC-C000-4 Fabric...
A ring radiator tweeter for detailed and extended high frequency response offering a low distortion sound representation.
SB29RDC-C000-4 Ring Dome...
This tweeter features a proprietary fabric ring dome with a large roll surround. Stabilizing the center of the dome greatly reduces distortion and brings the acoustic center of the tweeter back to the voice coil, with the added benefit of increased sensit
SB29RDNC-C000-4 Ring Dome...
This tweeter features a proprietary fabric ring dome with a large roll surround. Stabilizing the center of the dome greatly reduces distortion and brings the acoustic center of the tweeter back to the voice coil, with the added benefit of increased sensit
SB29SDAC-C000-4 Textile...
The SB29SDAC-C000-4’s large surround dome allows the increase of its acoustic output. Dual balanced compression chamber for improved dynamics. CCAW voice coil for low moving mass. Saturation controlled motor system for low distortion and low resonance fre
SB34NRX-00 12" Passive...
The SB Acoustics SB34NRX-00 passive radiator is a good match to the SB Acoustics woofer SB34SWNRX-S75. In 2.0 to 2.5 cubic foot box this combo will get down to 30Hz. Adding a plate amplifier with a low frequency boost would push the F3 even lower.
SB34NRX75-16 12" Woofer 16 ohm
This new 16 ohm 12″ woofer from SB Acoustic features a low distortion motor system, paper cone with rubber surround, cast Aluminum frame and 75mm voice coil. The woofer would make a fine low frequency driver for a premium 3-way system, or put two in paral
SB42FHCL75-6 15" honeycomb...
Light weight rigid honeycomb cone, hard paper honeycomb with fiber glass skin layers
SW26DAC-00 10" Passive...
SB Acoustics has made its new 10" passive radiator, the SW26DAC-00 to match their already active SW26DAC76 woofers. Simulating them in BassBox Pro produces some very good looking results.
SW26DAC76-4 10" Subwoofer 4...
The SB Acoustics SW26DAC76-4 10 inch 4 ohm aluminum shallow subwoofer. Can be used with very shallow enclosure’s.
SW26DAC76-8 10" Subwoofer 8...
The SB Acoustics SW26DAC76-8 10 inch 8 ohm aluminum shallow subwoofer. Can be used with very shallow enclosure’s
SW26DBAC-00 10'' Passive...
The SB Acoustics 10" passive radiator SW26DBAC-00 produces some very good results thanks to its main components: dual rigid aluminum cone structure and cast aluminum chassis that allows optimum strength.
SW26DBAC76-4 10" Aluminium...
The SB Acoustics SW26DBAC76-4 10 inch 4 ohm aluminum shallow subwoofer. Can be used with very shallow enclosure’s
SW26DBAC76-8 10’’ Aluminum...
The SB Acoustics SW26DBAC76-8 10 inch 8 ohm aluminum shallow subwoofer. Can be used with very shallow enclosure’s